Skip to main content

Getting Started Guide

Quick Start​

This guide gets your lighting control system up and running.

What We Will Cover​

Here is what you need to configure:

  • Device Commissioning: Add lamps, buttons, and sensors to your system
  • Input Setup: Configure buttons and manual controls
  • Scheduling: Set up time-based and astronomical schedules
  • Room Controls: Enable occupancy sensing and daylight harvesting
  • Commander Interface: Automatic commands

Before You Start​

Make sure you have:

  • Controller installed and powered
  • Network connection to the device
  • Web interface access
  • All devices connected to the bus

What to Expect​

Each section is hands-on with:

  • Step-by-step instructions
  • Screenshots where helpful

Need Help?​

Refer to the full documentation or contact technical support for assistance.